Products

BS5000 - Fabric heat shrinkable tubing

Applications:

The fabric heat shrink sleeve is warp and weft woven with polyolefin and polyester yarns, it is suitable for the automobile industry and various irregular-shaped wire harnesses and parts. Flexible and abrasion-resistant materials have excellent protection and beautification effects in various environments, and the ability to reduce vibration and noise. Avoid the noise caused by friction.

Operating temperature range:

Continuous operating temperature : -40℃ ~ 125℃
Minimum shrink temperature : 80℃
Minimum fully recovery temperature : 120℃

Color:

black

Standard color ：black (Other colors ,special size, cut pieces are available on request.)

Inquiry

Characteristics
Specification
Technical Data

2:1 shrinkage ratio
Anti-UV
Corrosion resistance
Excellently mechanical and weather property
Superior abrasion resistance property
Very flexible

Part Number.	Nominal Size (mm)	As supplied I.D.(min)	After recovered I.D.(max)	Packing Feet(Meter)/Roll
BS5000-0120	12	12	6	200(61)
BS5000-0200	20	20	10	200(61)
BS5000-0300	30	30	15	200(61)
BS5000-0400	40	40	20	200(61)
BS5000-0500	50	50	25	100(30.5)
BS5000-0600	60	60	30	100(30.5)
BS5000-0700	70	70	35	100(30.5)
BS5000-0800	80	80	40	100(30.5)

Property	Test Method	Typical Value
Transverse shrinkage	≧50%	50%
Longitudinal shrinkage	≦20%	20%
Abrasion test	1. Observe the surface of the sleeve after 144000 times of friction at low temperature -35℃. 2. Observe the surface of the sleeve after 144000 times of friction at high temperature 140℃.	No damage on the surface of Sleeve.
Long-term temperature test	1. After the high temperature 140℃/500 hours aging test, bent the sample180 degrees when it returned to room temperature and not allowed breaking. 2. Perform a -30℃/22-hour low- temperature test on the sample after high-temperature age. bent the sample180 degrees when it returned to room temperature and not allowed breaking.	No cracks after bending 180 degrees.
Short-term temperature test	1. After a high temperature 160℃/22 hours aging test, bent the sample180 degrees when it returned to room temperature and not allowed breaking. 2. Perform a -35℃/22-hour low- temperature test on the sample after high-temperature age. bent the sample180 degrees when it returned to room temperature and not allowed breaking.	No cracks after bending 180 degrees.